Set Up Instructions for Massarelli Two Tier Boca Round Fountain Water Feature

Open bag containing the pump kit P130DP. In the kit you will find:

40160 (160 gallon per hour pump)
rubber stopper
hose clamp
18" long piece of 1/2" clear tubing tube of silicone

1. Place pedestal on a firm and level surface where fountain will remain. Place the larger shell on the pedestal.

2. Find the pump, 1/2" clear tubing 18" long, the hose clamp and the rubber stopper. Place pump in pump house in
center of shell and run the plug end of the electrical cord down the PVC pipe located in the pump house and down into the
pedestal. Retrieve cord from under pedestal and place in groove in the bottom of pedestal. Slip the rubber stopper onto
the power cord with the smaller end facing away from the pump. Insert the rubber stopper snugly into the PVC pipe.
Make sure the pump is seated on the bottom of the pump house. Adjust position of the rubber stopper on the power cord
if necessary. Attach one end of 1/2" clear tubing outlet side of the pump with the hose clamp.

3. Position the larger shell on pedestal and level. To level shell, place level on the outside rim of the shell. Level in all
directions. Shim as needed.

4. Find the smaller shell and run the 1/2" clear tubing up thru the hole in the center housing of the shell. Position the shell
on top of the larger shell and level. Level as stated in step #3.

5. Cut the 1/2" clear tubing 4" above the top surface of the center housing on the smaller shell. Find the finial.
Insert the 1/2" clear tubing into the PVC pipe in the bottom of the finial and slide the finial down onto the center housing of
the shell. Position the finial on the fountain.

6. Find the drain plug and insert snugly into the drain inserts located in the larger shell. Remove any tape and or dirt from
the drain insert before you insert the drain plug. Fill both shells with tap water and plug pump into a 110VAC GFCI
protected outlet.

7. To adjust the water flow use the dial type flow control located on the front of the pump. This will regulate water flow
from the finial until the desired result is achieved.